Curtain
The shutter curtain is constructed from continuously interlocked twin-wall extruded aluminium laths securely held in place by endlocks thus preventing any lateral movement. The standard lath is 41mm high x 8mm thick with other profiles available included punched and glazed versions.

Bottom Rail
The purpose-made bottom rail is formed from a flat aluminium extruded section 51mm high with a rubber bottom seal.

Side Guides
The side guides are made from a reinforced aluminium channel 53mm wide x 22mm deep and is fitted with twin brush seals which make close contact with the curtain. The guides also incorporate an integral box section to allow concealed fixings whether side or face-fixed.

Roller
The roller is octagonal and manufactured from galvanized steel of adequate cross section and wall thickness to prevent deflection. Integral end shafts are fitted to engage into the die-cast aluminium endplates which support the shutter. Security tabs are fitted as standard to the roller to prevent the shutter being manually raised by unauthorized personnel.

Casing
The coiled-up shutter is housed in an attractive and compact head casing which is 165mm to 300mm square dependent on opening sizes. It is supplied as a two piece assembly and is fitted together on site using a lockseam-type joint thus avoiding any visible fixings.

Drive/Controls
The shutter is driven by a single-phase tubular motor mounted inside the roller and is operated by a low-level rocker switch. A further range of controls is available including keyswitches and remote controls by hand transmitter. All shutters with standard controls are pre-wired in our factory avoiding the expense of an electrician on site and merely require a 13 amp 3-pin socket at high level within 300mm of the motor.

Finish
All visible components are finished in a high-quality white powder coating as standard, other RAL or BS colours are available at extra cost.